Glass Bed Holders for Wanhao Duplicator i3

thingiverse

These parts securely hold a 213x200mm glass build plate in place on my Duplicator i3. I intentionally designed them to flex slightly, allowing for a snug fit even as the aluminum of the heated bed expands and contracts due to temperature changes. To install these holders, start by removing the thumb nuts used to level the bed. Next, loosen the screws located in each corner of the bed, giving them a few millimeters of vertical movement. Then, place the plate holders on the printer, making sure their broad sides face forward and backward. Finally, tighten the screws again, replace the thumb nuts, and gently press your glass build plate into position.