Glass bed corner 4mm glass Slotted

thingiverse

This version has been streamlined to fit 4mm glass without overhang, with a slightly thicker bottom, recessed cutout for the washer, and a slot that allows nut installation without removal.\r\n\r\nTake a look at the back side to see what I mean by slotted. This design still holds up against flexing when heating the bed to 65c.\r\n\r\nPrint with 1.2mm walls, 20% infill and use the experimental Tree Support in cura.\r\n\r\nThe only minor glitch is that I don't have a good way to print the inset ring at the bottom. If you flip the model, the part between the nut and bed isn't flat enough, and if you print it this way up, the support material is too thin to remove...