Gladiator Helmet for Skully

thingiverse

This marks the starting point for a series of accessories tailored specifically for Skully, available here: https://www.thingiverse.com/thing:2954166. The design was created with the 2" version in mind, but I'm confident that you can easily adapt it to fit smaller sizes. It's crucial to use supports during printing as the process proved to be a bit challenging. I had to make two attempts before achieving a successful print. Be sure to pay close attention to the nose piece, which only stays in place due to the supports until it reaches the top of the print. When slicing, this is an essential detail to keep in mind. Scaling down the design will undoubtedly add an extra layer of complexity, I suspect.