GIRO.remix - TEVO Tarantula / 40mm Fan BLTouch Mount

thingiverse

####GIRO.remix - BLTouch Mount####\r\n####General####\r\nThis remix is a reworked version of paul0's BLTouch mount for the TEVO Tarantula, designed to ensure precise alignment with the 40mm fan. The metal pin of the BLTouch must be positioned exactly on the X-Axis like the nozzle to avoid any X-Axis offsets.\r\n\r\nI added a protective cuboid to the back of paul0's mount to safeguard against cable damage from the fan. If your Tarantula is well-calibrated, this mount will fit perfectly; however, if not, use sanding paper to create additional space for the cables. Be cautious not to damage the cables during mounting.\r\nTo attach the BLTouch, you'll need M3 screws and M3 nuts.\r\nI also reinforced the wall of the holes where the M3 screws are inserted into the Chimera to prevent breakage from over-tightening.\r\n\r\n- - -\r\n####History####\r\n**Version 1.2**\r\nA Firebay Peanut Fanduct BLTouch mount was added.\r\n\r\n**Version 1.1**\r\nAdditional support structures were incorporated to enhance the stability of different BLTouch mountings following feedback.\r\n\r\n**Version 1.0**\r\nThis was the initial creation of the BLTouch mount.\r\n\r\n- - -\r\n####Printing####\r\nI strongly advise printing with exactly two perimeters, as otherwise some areas may not receive sufficient solidity. Printing at a lower speed, such as 30 mm/s, will yield more accurate results.\r\n\r\n---\r\n####Additional Information####\r\nIf you encounter any problems with the BLTouch mounting, please let me know so I can provide assistance and make necessary corrections. Your feedback is greatly appreciated and will help improve these mountings.\r\n\r\nIf my work has been helpful to you and you'd like to show your appreciation, a small tip would be greatly appreciated. I'd also like to thank those who have already supported me with a tip.\r\n\r\n\r\n\r\n[paul0's BLTouch mount]:https://www.thingiverse.com/thing:2817686