GIRO.ETS - BLTouch Mount

thingiverse

####GIRO.ETS - BLTouch Mount####\r\n####General####\r\nThis bracket is specifically designed to be mounted on top of the hotend enclosure, with the BLTouch positioned facing the right side and the cables carefully routed through the longhole in the bracket.\r\n\r\nTo complete the mounting of the bracket, you will need additional screws, nuts, and washers. The required parts are listed below.\r\n\r\n**Additional screws, nuts, and washers per bracket**\r\n2x M3x5 or 2x M3x10\r\n- - -\r\n####Printing####\r\nFor optimal results, I recommend printing the bracket with at least two or more perimeters. A lower print speed of 40 mm/s will help achieve a more accurate finish. Additionally, printing the bracket with at least 50% infill is highly recommended.\r\n\r\n- - -\r\n####Firmware Adjustments####\r\nTo set the precise position of the BLTouch within the firmware, you need to adjust the probe offset in the firmware settings. The following example code is for the Marlin firmware.\r\n\r\n#define X_PROBE_OFFSET_FROM_EXTRUDER 29\r\n#define Y_PROBE_OFFSET_FROM_EXTRUDER 0\r\n#define Z_PROBE_OFFSET_FROM_EXTRUDER -1.2\r\n- - -\r\n####Additional Information####\r\nIf you encounter any issues with the bracket, please let me know so I can assist and make necessary corrections to the design if needed. Your feedback is greatly appreciated.\r\n\r\nIf you find this work particularly useful, a small tip as a gesture of appreciation would be gratefully received.\r\n\r\n