Ghostbusters Wand with Pop & Twist

thingiverse

Updated 9/2020 with V2/MK2 wand body to work seamlessly with the most current source files. The remixed latch allows pop parts to function perfectly with the normal MK2 body. To achieve a snap-in bezel, only print the included body. For flexibility, print the front tube parts if you want to use PVC as the inner tube. This remix of several parts enables pop action with grip twist around a PVC inner support tube. You will need a 200mm section of 3/4" PVC pipe, a 20mm OD clear acrylic tube (with an inner diameter that can vary, but I used 20/16mm OD/ID), 1/8" metal rod, m3 screws (5mm, 10mm, and 25-30mm long), and two springs or rubber bands from a hardware store. It also accommodates the correct sized metal barrel tubing. When using the 160mm pop rod, the clear tube should be approximately 160mm in length, give or take. If you're using the 195mm pop rod, the clear tube should be about 132mm long, with some flexibility allowed. The red parts are printed with 100% infill, while the rest is at 10% with a .15mm layer height.