Ghostbusters Proton Pack Flair

thingiverse

We're trying to start a new trend in the Proton Pack building and customization community. Yes that's right, we have seven, count them SEVEN, pieces of flair ready for you to print and attach to your Proton Pack's booster section. Don't stop there, these pieces of flair can be attached, with super glue, to just about any area of your Proton Pack that will guarantee, GUARANTEE, to be a conversation starter at your next Con.I've cooked up two version from seven designs that will fit the flat nipple/disk from the MK3.1 or MK4 versions of the Q-Pack. The first design is based on the second most recognized logo in the world. The Ghostbusters logo. Just minus the ghost because it can get a bit crowded at such a small size. An amazing size, but small. And probably copyright. Mainly copyright. The second design is based on the logo for the newly christen Engineering division, but again minus the ghost.For design number three, we're bombarding the heart of New York City with unlicensed nuclear technology to honor the four ladies who took up the Ghostbusters mantel to battle a threat set out to destroy mankind, just as all threats do. Designs four and five pay tribute to the world's famous Hook and Ladder 8.And designs sixth and seven are the Gateway Arch paying tribute to the city that houses Harold Ramis' alma mater the Washington University in St. Louis.The two versions of each logo are…The MK3.1 version is sized for, and can be glued on top of the “QPack_3.1-EDA_nipple_flat.stl” file located in the SHELL > BOOSTER folder.The MK4 version is sized for, and can be glued on top of the “Q-pack-TacoShell_MK4_EDA_Disks-Flat_x2.stl” file located in the SHELL > TOP_SHELL folder.But don't let their size fool you. Let your imagination run wild. Resize, print, and glue these suckers anywhere. I'm trying one out on the “Cheese Slice,” for my wand.I hope you all enjoy because WE'RE READY TO ACCESSORIZE YOU!