Ghost Lamp

prusaprinters

This ghost lamp uses black eye inserts, printed separately, for a spooky ghost glare.  The shell is 2mm thick for a sturdy lamp that will last.  A lamp kit using a C7/E12 LED bulb will be needed to complete the project.  Lamp kits are readily available on Amazon, Hobby Lobby, and Ace Hardware, and other stores.  A photo of a lamp kit is included.This ghost lamp was printed using Polymaker Polylite White PLA filament, which has good light transmission.  Most any white filament should work fine, especially white filaments commonly used to make lithophanes, such as eSun white PLA+.Lamp dimensions:Height:   155mmWidth:  98mmPrint settings used are as follows:Body Layer height:  0.2mmWalls:  2Top Layers: 3Bottom Layers: 4Body Infill:  5% Eyes Infill:  100%Supports:  Enabled    Supports Density:  25%Supports are required for lamp LED opening support and back of eyes supportAdditional parts needed:A C7/E12 LED lamp kit - https://www.amazon.com/Kiraralite-Accessory-Candelabra-Equivalent-Incandescent/dp/B0BPS7G5YD?th=1Note that some kits include an incandescent bulb and many craft stores and even hardware stores stock them.  *** Use ONLY LED bulbs with this lamp. ***