Gherkin keyboard Case

thingiverse

This is a Case for the Gherkin (Bluetooth + QI Charger) Keyboard. It has only one hole in the bottom for a physical switch. A warning popped up stating that the print was too large for my Ender 3, but I found it fine to print one by one horizontally in the supplied orientation. I used Wood PLA, so the resolution was 0.5, and if you're using PLA, you may want to set your resolution to 0.4. No supports are needed. The top plate is intentionally tight; you'll need to sand off the inner walls a bit, and it should snap into the bottom case snugly. This case is compatible with both the "double-pcb gherkin" or the gherkin using the top-plate for switches. You can add a sponge or sorbothane sheet between the pcb and casing to optimize sound and reduce shake.