'Get Bent AFG' Remix for Mac N Cheese

prusaprinters

<p>Remix of the FFFTechnology “Get Bent Stubby AFG” modeled to fit the Mac N Cheese.</p><p>What's changed:</p><ol><li>Attachment area was made smaller to only cover the three 1913 slots on the Mac N Cheese front receiver without bottoming out against the back.&nbsp;</li><li>Applied the “textured” variant pattern to the bottom half.</li><li>Recreated the contours of the grip (not by choice--couldn't split the attachment area off without destroying the original curvature). However the “knuckle” is now much less visible.</li><li>Made grip area larger. Grip is 4mm wider and ~3mm taller.</li><li>Offset 1913 interface walls very slightly to allow for easier installation without having to wack it onto the rail, especially if printed with “fuzzy skin” setting.</li></ol><p>&nbsp;</p><p>Check out <a href="https://www.printables.com/social/113219-ffftechnology/">FFFTech</a> for all of their great designs.</p><p>&nbsp;</p><p>Notes from original model:</p><h3>Installation</h3><ol><li>Press the M5 hex nut into it's indexing socket.</li><li>With the hex nut installed, slide the forgrip onto the rail and align the bolt channel with<br>&nbsp; the preferred rail slot of installation.</li><li>Drive the bolt through the channel and start threading into the hex nut.</li><li>Tighten the bolt into the hex nut until the foregrip is mounted firmly in place. The end of&nbsp;<br>&nbsp; bolt shouldn't protrude past the hex nut indexing slot. Avoid overtightening the bolt.&nbsp;</li></ol><p>&nbsp;</p><h3><strong>Print instructions</strong></h3><ul><li>Print Settings:<ul><li>Extruder: 204C&nbsp;</li><li>Bed: 56C&nbsp;</li><li>First Layer Print Height: .20mm&nbsp;</li><li>Standard Layer Height: .14mm</li><li>Wall Thickness: .40&nbsp;</li><li>Wall Perimeters: 3 - 4</li><li>Infill: 20%</li><li>Infill Pattern: Gyroid</li><li>Material Flow: 100%</li><li>Support Material Percentage: 18%</li></ul></li><li>Print upside-down, using support material only for the rail slot.</li></ul><p><br>&nbsp;</p>