Gerber Suspension Slide Case - Molle Mount

thingiverse

This remix replaces the original belt loops with "locking" Molle clips. Several changes have been made to the clip and case design to more easily print without supports. I've also included a version with a small snap-out support I created manually, but haven't tested. A few of the back corners have also been rounded off. This normally isn't needed, but I wear this on the front of a backpack shoulder-strap, and any edge ends up scraping me when I'm hiking and moving around. I also remade the STL, as Prusa Slicer didn't like something about the belt loop version - it wasn't bringing in one of the locking bars correctly. Print upright, and side-on so the Molle clips don't flop back and forth as it prints. (sideways is much better supported) Tested with PETG on a camping trip this weekend, seemed to work fine.