GepRC Leopard (LX4 LX5 LX6 LSX) Racing Pod

thingiverse

I am releasing this content on the condition that it is only printed for personal use. Anyone found selling these designs will be reported to the platform where they are discovered, resulting in a breach of license agreement and potentially affecting my future decisions regarding releases. Here's a racing pod I've designed specifically for the GepRC leopard. It fits the Runcam Swift style of camera perfectly, which is why I'm using it with the Rotor Riot version of the original Runcam Swift. To assemble this pod, you'll need: 2 x M3x20mm cap head bolts to secure it to the rear frame 2 x M3 Nyloc nuts to bolt those into place 2 x M3 standard nuts to push into the nut traps inside the front of the pod For mounting the camera to the pod, I used standard screws. The long ones went through the plastic holes, while the short ones fit into the brass threaded holes. I'm using a Matek VTX pigtail, which doesn't have lugs on the side of the SMA connector like the TBS does. I'm unsure if you can attach a TBS SMA connector to the pod. My receiver antennas are mounted under the arms, as shown in the photos. If you prefer not to do this, you could use cable ties and attach them to the hexagons on the rear of the pod instead. I printed this design from Surreal TPU at 0.2mm layer height and 25% cubic infill using supports with a 75% support interface and a roof. I blocked supports in the camera bolt holes and above the nut traps at the front of the pod to make them easier to remove. Enjoy your new racing pod!