George Jetson

prusaprinters

<p>George Jetson, from the comic strip The Jetsons, by Hanna-Barbera.</p> <p>George resides with his family and his dog Astro in Orbit City in the future. His personality is that of a well-meaning, caring father, but he is often befuddled and stressed out by the problems of both his work and family lives.</p> <p>No supports are required. If you have the proper filament colors, no painting is needed.</p> <p>The model is 260mm tall. Due to some small parts, the model should not be sized smaller, but can be sized larger without issue.</p> <p>Enjoy!</p> <h3>Print instructions</h3><p><strong>Print Settings</strong></p> <p><strong>Printer:</strong> FlashForge Creator X<br/> <strong>Rafts:</strong> Doesn't Matter<br/> <strong>Supports:</strong> No<br/> <strong>Resolution:</strong> .2mm<br/> <strong>Infill:</strong> 10%</p> <p><strong>Notes:</strong></p> <p>See below for helpful printing and assembly tips.</p> <p><strong>Building the model</strong></p> <p><strong>Colors</strong></p> <p>Black:<br/> eyebrows<br/> eyeblacks<br/> mouth<br/> ring_top<br/> ring_bottom<br/> stripes<br/> buckle<br/> ..<br/> Beige or Flesh:<br/> head<br/> hand_left<br/> hand_right<br/> ..<br/> White:<br/> shirt<br/> shoes<br/> arm_left<br/> arm_right<br/> eyewhites<br/> ..<br/> Orange:<br/> hair_top<br/> hair_bottom<br/> ..<br/> Blue:<br/> pants<br/> ..<br/> Green:<br/> belt<br/> ..<br/> Red:<br/> tongue<br/> ..<br/> Any color (hidden pieces)<br/> pin_belt<br/> pin_hair<br/> ..</p> <p><strong>Printing and assembly tips</strong></p> <p>Printing tips<br/> 1-As with most of my models, no supports are required.</p> <p>2-Be sure to clean any first layer squish if you have any problem joining parts. The parts should fit nicely when printed cleanly or with a slight first layer squish.</p> <p>3-I did not require any rafts or brims for any of the parts, however use your judgement as some parts have small bases:<br/> hand_left<br/> hand_right<br/> arm_left<br/> arm_right</p> <p>..<br/> Assembly tips:<br/> 1-The left/right eyebrows are quite small and are actually modeled to fit a certain way, however since they are so small that as long as they look good it should be fine any way they are positioned.</p> <p>2-The left/right eyewhites and left/right eyeblacks are interchangeable.</p> <p>3-Before gluing the stripes and buckle, be sure to bend them a bit since they are being glued to a slightly rounded part.</p> <p>4-If the rings around the pants are too snug, simply sand a tiny bit off the part that touches the pants. A tiny sanding makes a big difference in how high the rings fit.</p> <p>5-Since there are a bunch of tiny black parts I printed two sets of each part. I knew I'd drop and lose a part while putting the model together.</p> <p>6-Refer to the assembly diagram for putting the model together. The model is meant to be glued.</p>