Geometric Cat FULL jig

thingiverse

SUPER SIMPLE JIG - READ!!!! Ok I took the entire PDF, converted to STL then cut up into about 200x200 sections. This is a down and dirty simple jig that should suffice for people that wanted one to at least be able to get 90-95% of it aligned. Each piece is numbered by coordinates an I included the full map so you can see where Z1Y1X1 starts and such. I resized the cat to 102% before cutting it out of the cube so it should give a little wiggle room to be able to remove the jig after you put the pieces on the wall. CHANGE Z HEIGHT TO YOUR LAYER HEIGHT on each piece, or whatever you want really but I was thinking to keep this super thin and just use scotch tape to stick it on the wall as a guide. It will take a while to print but people were asking for it so I figured, why not. I figured someone will see this and maybe do a nicer one that has cuts along the parts so it doesn't have anything hanging away from the main body but if not, should be good enough I think. This would be a great use for that super cheap color change filament you can get from iiidmax