Geoffs Masonry / Brick / Concrete / Wall Anchor Plug

thingiverse

I got fed up with the lousy products Bunnings sells here in Australia - masonry anchors that don't hold a grip - they either fall out or spin when the screw is tightened. Here's my version that works great for me - plus, if the size is off by a hair, just print one that fits perfectly - it only takes a few minutes to get it right. They even have the size printed on the bottom - although it can be a bit tough to read on the smaller sizes. Printed with ABS plastic - though PETG would be more flexible and useful if you happen to miss your mark with a hammer. Printer Settings Printer Brand: Solidoodle Printer Model: Solidoodle 2 Expert Rafts: None needed Supports: Not required Resolution: I used .2mm, bigger should be fine too and faster to print Infill: ABS at 100%