Geodude

thingiverse

A wild GEODUDE appeared! This Pokemon model was sourced from roestudios.co.uk, a site that extracts models from various games. I then optimized it for 3D printing. Feel free to enhance or remix this design. Remember, Pokemon is copyrighted by Gamefreak/Nintendo. Pokemon enthusiasts: check out my functional 3D-printed PokeDex. I printed the GEODUDE on a FlashForge Creator 1 (similar to the Replicator 1). I employed grey ABS and applied these settings: No raft, exterior support (essential for this model), 10% infill, 0.2mm layer height, three shells, feedrate at 40 mm/s, travel feedrate at 55 mm/s, and a printing temperature of 230 degrees. It took approximately three hours to print using these settings.