Genshin Impact - The Stringless

cults3d

This model is cut into 10 parts to fit in Ender 3 with a platform size of 200mm x 200m x 200mm. There is a picture of parts labeled to their file name in the preview section which you can refer to. All the parts have a flat face that can lay on the printing bed. Some of the pieces have a small face lying on the printing bed that you need to pay more attention to. It is suggested that you print at a very slow speed for the first 10%-15% of the progress. A brim is suggested as well for better adhesion on the printing bed. Just in case all the suggestions mentioned above did not solve your problem, you can slice the part in half so that it can have a bigger face to lay on the printing bed. Tunnels of 5mm and 10mm were also punched on the model for bone installation and alignment purposes. Removing the support on the model is quite difficult, especially since some tunnel is quite close to the surface. I will suggest using those tunnels as a guide for you to drill your hole. Once all the parts are printed, glue them together using super glue or the PLA melting method. For scaling please use the same scale factor for all the pieces. Cheers and Happy Printing!