Genshin Impact - Light of Foliar Incision

cults3d

This model is cut into 14 pieces to fit a printer with a platform size of 200mm x 200mm x 200mm. All the pieces come with a flat face that can lay on the printing bed. However, there will be support needed in some of the parts such as 3a and 3b. There is a picture of pieces labeled to their file names in the preview section which you can refer to. An uncut version also included for you just in case you need it. Once pieces a and b are printed, glue them back to back using super glue or other suitable adhesives to form a part. Repeat the same for the other pairs and join them afterward. tunnels with a 10mm diameter are punched on the model as well for alignment and bone installation purposes. Since the total length f the prop is about 1200mm after assembly, therefore bone can be ignored if you print it with low infill. There is a "peg" file included in the listing as well. It is a 9.5mm diameter cylinder. You can print this file if you can't find anything with a similar diameter for the purposes mentioned above. For scaling, please use the same scale for all the pieces. Cheers and Happy Printing!