GENIUS FIRMWARE 2.0.9.1 + Tft Genius logo

thingiverse

Well, i decide to do some firmware for the genius because all the firmwares i found here was for X1 and also the ones they said "genius" you can see is for the x1. just to let it clear i did without BLtouch because i really dont think it is necessary for a 220x220 bed. so... if you have Bltouch is not for you :( to install its really easy. the steps are: ----Firmware----- -disconnect the electricity -turn the printer to one side and take out the 6 screws, open the printer(down) - disconnect the cable of the tft( screen) -connect your cable to the printer and your pc. -open cura, setup printer. -actualization. -load from the computer the firmware.hex. -perfect you did half of the work! -now disconnect from your printer the cable. -connect the cable of the tft(touch panel). -close the printer. ----tft actualization---- -open the folder tft genius -open the folder of language packs and choose your language copy it. -go one page back and paste where config.ini and the other files are. -copy all the files of the folder and paste in a micro sd card. -put it in your printer and turn your printer on. -now just wait till it ends and that's it.