Generator Airbox Lid

thingiverse

This is an airbox lid made specifically for the Centurion/Generac 5000w generator. I found the entire assembly for around $30-50, but not just the lid, which was carelessly discarded by someone who bears a striking resemblance to me. The inside dimensions of this cover measure 158.75mm x 266.70mm x 20mm. To ensure your air filter assembly has sufficient clearance, carefully measure the depth (20mm) as this can vary across different models and years. To attach this lid to the assembly, I used two self-tapping screws inserted from the inside out at the middle of the top and bottom. The screw ends were then ground down to remove any points, after which they were secured to the existing tab on the assembly with a small zip tie. Since the unit is not exposed to direct heat, melting is unlikely. However, I must emphasize that I am not responsible for any potential fires, damage, harm, or negative experiences resulting from using this creation. If you choose to print and utilize it, do so at your own risk. In theory, this design should also fit models like the Generac GP5500, GP6500, and GP6500E portable generators.