General purpose hobby syringe

prusaprinters

<p>General purpose hobby craft syringe to apply glue, grease, cake-icing, paint and other liquids into difficult to reach places.<br/> The syringe has a fine extrusion however this can be opened up by shortening the nozzle with scissors.<br/> Regular size 3.5ml and large size 7.5ml syringes complete with plunger, cap and optional sealing rings.<br/> The plunger is a close fit to the tube but should move fairly freely. You may need to trim around the opening of the tube with a knife in order to insert the plunger if the first layer has printed thickly.<br/> The optional sealing rings should be printed from soft plastic such at TPE however you might prefer to use silicon rubber o-rings, PTFE tape or other sealing material.</p> <h3> Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div><strong>Resolution:</strong></p> <p>0.2 layer height or less</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>15%</p></div></p> <p><strong>Notes:</strong></p> <p>0.4mm extruder printed with 3 x top/bottom layers. 2 x wall layers. Other settings should work. The syringe is thin wall and should be printed with print head temperature 10 degrees above normal and no more than 50% cooling fan for good adhesion.</p> <p>Regular syringe print height 120mm .</p> <p>Large syringe print height 170mm.</p> <p>Print 2 x seal from soft plastic such as TPE or use rubber o-rings or PTFE tape or other sealing material.</p> </p></p> Category: DIY