GeekPi 7inch LCD Touchscreen Mount

thingiverse

Designed this case\mount for use with the Creality 10S (should work with other creality 10 series that use the standalone control box). For use with GeekPi LCD Touchscreen I got on Amazon (price has sadly increased on this screen, yet it is a good one) https://www.amazon.com/dp/B075QCXLPF If you are printing the back_mount I highly advise to print with the larger screen side facing down. This will require using supports for the indent that the monitor will sit in. Yet for me, this came out very easily. There is an included test print for the angle that the case mount is positioned to, alternatively that can be used as a door stop when done. Also included a back "plate" that can be used with the monitor without needing to attatch it to a printer control box. The holes are smaller than needed. This is to ensure a snug fit. Since the print is thin enough it acts like it is tapped. I used either 2.5M or 3M bolt, Sorry I I forgot which one. Please check that you are not damage the circuit board of the screen if you print, and use other screws. Due to cooling and warping after prints, it is possible that the screw holes might not line up. I used a knife to make on of the holes a bit bigger to compensate for this. Post-printing. The cutout for the inputs (HDMI\USB) on side could benefit from a larger border, however I just used the bolt\nut to kind of close this off. For me it is acceptable, yet I do agree it isn't perfect.