Geeetech Prusa I3 Pro B Dual Bowden extruder holder adjustable for E3D V6 or clone

thingiverse

This is a custom dual holder design for the Geeetech Prusa I3 Pro B printer. Hardware Components: Two M3x50 screws are required for mounting sensors, or use M3x25 screws without sensors; Three M3x25 screws and three M3x10 screws will also be needed. Four M3 square nuts and four M3 hex nuts are necessary. Eight M3 washers are required, as well as one spring with a 7mm outer diameter and a 10mm length. Marlin Settings: The following Marlin settings have been defined: EXTRUDER_OFFSET_X is set to 0.0, 28.20 EXTRUDER_OFFSET_Y is set to 0.0, -3.00 A Fusion 360 file for this design is available for download. Update: One key change has been made to Holder 1, allowing users to remove the push fit connector without removing the hotend. Printing Settings: Printed on a Geeetech Prusa I3 Pro B printer, No rafts are used, Supports are enabled and will touch the bed only. Resolution is set to 0.2 mm, Infill density is 50%.