Geeetech G2S Top Stabilizer - On the Outside

thingiverse

Stabilizer for the Geeetech G2S Delta 3D Printer. It barely wobbles after installing the top stabilizer and bottom stabilizer mentioned below. Print as in the second picture, rotating 90 degrees on X and -45 degrees on Y. I used 20% infill and 0.3mm PLA. I might try ABS another day. Black will look better than magenta, so I'll also try that later. Remixed from: http://www.thingiverse.com/thing:1912495 (Took measurements for the vertical bars.) That one was installed inside the bars. It's a great idea, but I found the area too cluttered. My design envelops the top of the printer and uses it as support, eliminating interference with all important parts. That part was remixed from: http://www.thingiverse.com/thing:1817718 Print Settings: Printer: Geeetech Rostock G2S Rafts: No Supports: Yes Resolution: 300 microns Infill: 20% How I Designed This Download the code from OpenSCAD.