Geeetech / CTC Prusa i3 DIY - Z Axis Bracket Remix with printable Bearing

thingiverse

Human: Remix which has different kinds of structural holes bigger hole for the bearing more float for M8 rods without bearing printable bearing - normal quite loose should work right away but not recommended see NOTE below tight make sure inner is wide enough for rods use drill to widen if necessary NOTE: Check my blog post https://spiritdude.wordpress.com/2018/07/15/3d-printing-fixing-z-banding/ about the use of this upgrade. In essence, leaving it open or using the tight bearing works best the existing wooden Z bracket or the loose bearing might give significantly worse results. Your experience may vary depending on the severity and kind of bending of the threaded rods.