GeeeTech Clip-on Wire Cover

thingiverse

Not so fancy cover designed for seamless mounting on your printer. Simply print it with your preferred settings and you're ready to go. This straightforward solution conceals those wires located right next to the x-axis motor with ease. No screws are required, making installation a breeze. This design may also be compatible with other 3D printer structures out there. The screw hole diameter is precisely 12mm, measured from its center point. The joining clip in the middle is optional but serves to securely hold these covers in place. However, it does make them slightly harder to remove without applying some force. This cover is intended to be semi-permanent, providing a stable and secure solution for your printer's wiring.