Geeetech A10T Small modifications

thingiverse

First, I'd like to give credit where it's due - the cutting guide I used is available at https://www.thingiverse.com/thing:3126464. To ensure reliability, I opted for a cautious approach with the PTFE tubes. These components are notorious for coming loose at the hot end's lower end, so I decided to perform the captive hotend mod. This design can be found at https://www.thingiverse.com/thing:3671940. One challenge I faced was locating the memory card slot without visually inspecting it. To make this task easier, I created a custom surround that secures with double-sided tape. In addition to the surround, I also designed a filament storage box. However, my plastic tube measured 42mm in diameter, which differed from the original design's specifications. As a result, I fabricated a 42mm tube mount held together by three 3mm bolts. For the dry box feeds, I drew inspiration from https://www.thingiverse.com/thing:878919. Meanwhile, my box mounts were based on this design found at https://www.thingiverse.com/thing:743280.