Geeetech A10M Fan duct v2.0

thingiverse

Hi rabbits, This is my second approach to a fan duct for the new A10M model from middle 2020. Based on herome series, I use the 40*20 fan and the curved pipe to allow the air flow from fresh air. You will need to combine this fand duct with the layer duct from https://www.thingiverse.com/thing:3332813 choose the one 5015 layer blower or the two 5015 layer blower. Try to print as shown in the image on cura bed, so you will minimize the use of supports, despite a little colapse in the fan support. The images are from the giantarm grey pla, just for testing it is fine, currently this pla fan duct continue on the printer, but if you want a heavly use, try to print it at least on PETG. **IMPORTAN NOTE:** Since the lower screw holes are in PLA/PETG whatever material you use, try not to tight them to much or you will break the support. Just tight it with out any pressure or brute force.