Gear 1 (x2) 16 teeth, diameter 2,52 cm

thingiverse

Here is a customized version of the item located at http://www.thingiverse.com/thing:844671. Created with Customizer! You can also use this same tool to modify it further at http://www.thingiverse.com/apps/customizer/run?thing_id=844671. Now let's take a look at what you need to do with the following settings: Use these parameters to build your custom item: df_gear_ring_thickness = 10 Select df_type = 0 from your available choices. Choose the number of teeth, 16 in this case. Set df_gear_height = 7.5 to fit your project. df_tooth_clear must be at least .03 or higher. Adjust your scaling by setting S_fn to a minimum value of 100. Next choose df_tooth_deep from your list and make sure it is at .03 or greater. Finally adjust the heated bed settings according to what you are doing: Num_slice equals 40, and your heated bed size is going to be set at both length and width equal to 210. Last but not least: for all three parts of the thing that will use a df_pencil_diameter no bigger than 1. Then for any piece with teeth on them select their df_tooth_diameter as big or slightly over 4.95