GE Upper Rack Axle V2

thingiverse

This is a remix of Fugops44's axle made for the Triton XL dishwasher. I believe it might also be made for other older GE washers as well. Thanks to him for doing the bulk of the work!After printing, I found the axle did not fit properly, so I rebuilt it, increasing inner and outer diameter. I also improved the bevel and cutout in order to get the wheel on easily. I made it slightly thicker than the original, so it should be a bit more stable and less prone to the angular wear that causes them to fail in the first place.Support material is needed for the bottom platform. I used manual support painting to only create supports for this part of the model. I used ABS for this axle with 100% infill, make sure you use a filament that can sustain high temperatures. PLA is not suitable for this use case and will fail on you. Hope this helps!