GE Electric Dryer Knob

thingiverse

The crack for my switch started spreading up the side. This is a backup plan. It's not as thick as the original. Designed to print with zero support and use little material yet stay strong enough to never snap (which the original snapped). I include two versions. One where the flat section of the crack aligns with the mark and another where it is twisted ninety degrees. My airer uses both of these alignments used for some reason. I added the test print used to check the fit as well as original sketchup files for each. The photo shown is ABS at point two two millimeters with sixty percent infill. I chose not to paint the mark with blue acrylic because I forgot it in my desk.