Gauss-tower (28mm)

cults3d

Hi !\n\nThis is a request by Crisiinvolo. (cover picture is his print and paint job)\nI modelled it from scratch with CREO, based on pictures\nI tried to capture every little detail I could see :-)\nIt was really fun to create\n\nI'm not 100% sure about dimensions and proportions, but it should be accurate for 28mm\n\neverything should be easily printable, as oriented, with a few supports where necessary\n\nPrint list : \n6x foot\n2x ark_side + 2x mirror\n2x ark_center_V3\n1x base\n1x tray\n2x claw\n1x lower pivot\n1x upper pivot\n1x axis\n1x lock\n1x crystal - could be probably printed hollow with clear green filament ?\n1x pedestal A &B\n1x crystal top A&B\n2x crystal lateral support + 2x mirrored\n2x crystal side support + 2x mirrored\n2x ark tip\n6x pylon arm\n2x lateral tube\n\nAssembly requires 6mm and 4mm rod\n\nedit 15/10 : a little part was missing in the ark_center part. I uploaded a V2, and the missing part for those who already printed the V1\n\nedit 16/10/2017 : the link parts between base and ark are online!\nassembly instructions : DON'T GLUE IT\ninsert the lower part under the base\ninsert the pivot part above the base\ninsert the pivot inside\ninsert one claw on each side of the ark, and insert the whole on the base\nLock the assembly with the little lock. If necessary, adjust the height of the lock\n\nedit 17/10/2017 added crystal and his pedestal and supports\n\nedit 19/10/2017 : finished, all parts are online !!\n\nedit 24/12/2017 : added pylon center V3 (thanks 0000xl for the detail)\n\nedit 11/02/2018 :new version for pylon center and ark_side with 4mm holes for alignment pins\n\n== Please consider sending tips if you like my printable models ==\n\nCopyright infringement is not intended. Parts are created freehand in 3d modeling software, no copyrighted product had been scanned or copied in any way. These models are for personal use as proxies and should never be sold. If it causes copyright issues, I will remove them.