Gaslands Tracker Dials

thingiverse

Trackers for Gaslands, Dials display 0-9, click into place to hold position. All Dials read 0-9, EXCEPT the shift dial. It reads 1-6 with 2,3,4, and 5 being repeated. This is so the dial can keep counting 1-6 without having 4 useless spots. You will only need this dial for the shift_box, all others get the regular dial. Only the 2 dial hazard and hull points boxes need the 2 dial rod, the rest use the 1 dial rod. Supports help, but I accidently ran 4 of these without support and they came out fine, YMMV. It takes longer, but looks a lot cleaner if you print at .2 layer height or smaller. .3 will print faster but look a lot messier and may not fit together as well due to tolerances and clearance. All files are oriented for print as is. For the switches, they click into place in up and down position, you must install the spring the right way as shown in the picture above for best results. I used a small dab of super glue on each half of the switch box to ensure a better hold. As always, if you have any question feel free to message me.