Gas cooker folding base (for 100g gas cartridge)

prusaprinters

Print 5 pieces of slats out in PETG or higher temperature resistant material (there are 5 on the plate in the .stl) and clip them together. It should be pretty obvious how they go together. Look at the photos if you can't figure it out. For ease of design and printing I have designed the slats to be all the same, but the last one needs to have the tip of the clip bit cut off to unfold properly. Use pliers or side cutters to do this.unfold the base and clip the slats individually on the folded edge of the cartridge. Don't just place it on the base and press down, this doesn't work (and will probably break it). To disassemble unclip them individually and fold the base.While cooking, make sure that the base can't get too hot, or it will go soft and fall over. All the common precautions apply. Don't leave it unattended. If the pot overboils and drips on the slats it can fall over. The design uses 5 feet because they offer a level of redundancy, but that doesn't mean it's absolutely safe.