Garmin or Wahoo Aerobar Parametric Mount

thingiverse

This is a custom OpenSCAD design that lets you change the WIDTH, HEIGHT, and FORWARD lines at the top of the file to create a mount. WIDTH should be the measurement in millimeters from one aerobar to another, the HEIGHT should be how many millimeters the mount should rise over your bars or a negative value to have it dip below your bars, and FORWARD should be a value 0 or greater for how far forward to shift the mount depending on the shape of your cockpit. I created this so I could mount my Garmin where I wanted on my Giant Trinity Advanced bicycle which has an integrated water bottle that blocks most mounts. Positive and negative HEIGHT values let you position the mount to be even with the top of your water bottle, so that refilling your bottle is not blocked, especially when combined with the FORWARD parameter. You'll need a recent generation OEM Garmin mount to unscrew the center of the mount from and attach it to this. You'll also need 0.75 inch Velcro fastening tape to put through the slots and wrap around your bars to hold it in place. I also put some adhesive Velcro on my bars themselves for the fastening tape to attach to, to prevent the mount from sliding around. **Note for Wahoo Elemnt Users**: You can use a Garmin mount insert in this with your Element, just rotate it 90 degrees using the horizontal bolt holes, and make the notch holes of the insert about 1mm wider on each side by trimming them with sharp cutters you already likely have for your printer. It will still work with a Garmin as well. Change log: * v1.2.1 - 2019/12/21 - Add additional bolt holes to rotate mount inset 90 degrees to support Wahoo Elemnt computers * v1.2.0 - 2019/11/19 - Add support for angling Garmin itself forward or back in relation to the clamps * v1.1.1 - 2019/10/31 - Add support for angling the bar clamps, and make the HEIGHT value more sane in that 0 makes the mount flat as expected * v1.0.0 - 2019/08/31 - Rewrite and clean up; better clamp generation, and support for negative HEIGHT values * v0.0.2 - 2019/08/07 - Fix bolt hole positioning; Add support for FORWARD parameter * v0.0.1 - 2019/08/06 - Initial version