garage flashlight

thingiverse

I'm still working on completing the design, hoping to get back to it soon. Electronics: Two 12v LED strips are used. Three 18650 batteries connected in series provide 12 volts. A simple switch is included. The cap (bottom part) is attached with two M3 screws. Two additional holes were drilled for potential future use, but the existing ones proved too small and needed to be threaded. The hook is secured using a strong 2-part epoxy adhesive. Hot glue holds the LED strips in place. Dimensions: Height: 290mm (29 cm) Outer diameter: 38mm Tip: If you want the flashlight to stand upright on its own, make sure to print a base for the cap. I didn't include this feature since I plan to hang it on a wall when not in use.