Gandalf the Grey's Staff - Life-Size

thingiverse

Scaled up to be 6ft tall. In hind-sight maybe this is about 5% too big. Hole cut out through the staff to fit a 3/4" dowel. Removed an egg-shaped cavity in top of the staff that is printed separately in order to fit lights inside. The orb files should be printed with 0 infill and no top or bottom layers (horizontal shells in PrusaSlicer) corresponding to the center. Vase mode should also work. There are some cutouts for magnets for holding the orb together, but they need to be very strong. I ended up just using clear tape on the orb to hold it together. The original model was extremely high detail, so there is also a large loss of surface complexity compared to the original.