Gaming controller hanger

prusaprinters

If anything is off or you want it fixed, please let me know in the comments.this has been tested and verified to hold a controller on an overhang to help with space while making sure it doesn't fall. Compatibility Please note that this is made to fit comfortably on an overhang of 30-30 mm however it should work as long as those measurements don't vary in over 5 mm on both sides.Make instructions:if possible on your slicer, please add the fuzzy skin setting to the Holder Pin only, for adding it to both pins will prevent them from sliding into each other all the way and may result in your 2 pins becoming 3.If you don't put fuzzy skin on at all or put it on the opposite piece will cause your hanger pieces to slide and could eventually result in a boxing match of Controller VS Ground .AfterthoughtI will most likely add a sliding feature to make it so you can add an adjustable feature so you can use it on different types of sizes Ex: 45-45 mm bar.So expect this updated whenever I can.and may add an image tooI would love to see your prints if possible posted 👍