GameCube Microphone Stand

thingiverse

Recently I obtained a GameCube microphone and the game Odama, but the controller clip wasn't included (and wouldn't fit on my RetroFighters BladeGC anyway).Since I planned on using the mic while streaming the game, I realized it would be a good idea to make a stand to hold it up.I've used Fusion 360 to make some pretty simple models before but all of them were mostly flat, so I decided to challenge myself to figure out how to make something fully 3D. Took a couple hours of work (and one redesign, the first design was about 1mm too small for the mic) I had this little mic stand design.This is the final result! If you need something to hold a GC mic, I hope you find this useful!