Game Of Gimbals

thingiverse

Human: I managed to print the ring tower twice with a raft, but every attempt failed as the rings didn't stick to it properly. Despite applying blue painter's tape all over the build plate, they refused to adhere to that too. The only possible clue was seeing gimbals in an HBO logo and during Game of Thrones' intro; therefore, I named this creation Game of Gimbals. Have a great time! Thanks go out to mphardy for their input! This customized version originated from thingiverse.com's thing: 73634, while Customizer generated it with help found at http://www.thingiverse.com/apps/customizer/run?thing_id=73634. Instructions: I chose these options to generate this specific design: Ring pin diameter = 2.45 mm Build Plate manual width and length set at 280 by 170 respectively The space between each ring is a full inch Height increment per layer is set to .5 inches The highest point of each tower segment measures six units high Every circle section's side width will be exactly five mm. Every metal piece attached atop every tower pin measures three and forty-five hundredths Diameter on their respective holes was determined at 3.05 As my chosen platform doesn't support printing objects without an adhesion layer underneath the bottom surface – hence the designation "Manual" within this Build Plate parameter listing; all my selected values above should lead to the desired product coming off clean once I start operating it