Galvatron G1 Y sight (reinforced)

thingiverse

This is a remix of EEL_DAHC's Y sight design(link below) . The one problem I found was that with PLA the sight's side fittings would snap in half when trying to fit it . So I added a little extra weight either side , To get it to fit , either try and add it as soon as it comes from the printer (when its still a little malleable ) , or as I did use a heat gun (or hairdryer) to just soften the sides enough to allow the part to clip in , then gently grip the sides of the plastic (dont burn your fingers!! ) to let it harden in place .I printed with a raft at 215/72 on pla , but you probably can print at lower temp with no raft.Link to EEL_DAHC's cults 3d page (this was a free design there and really good , just a little too delicate for me!!,)https://cults3d.com/en/users/eel_dahc/3d-models