Galaxy 1 Vat Clean

thingiverse

vat cleaning print for the Galaxy 1 from emake3d. Slice this as a regular print, remove the build plate and start the print. Use an old piece of support material to create a pull handle by placing a 1in x 1in scrap support in two corners of the build plate. Offset from the corner of the vat by about 1 inch. Start the print, let the build plate arm lower without the build plate installed and let a few layers of the print run then stop the print. Gently pull the support scrap handle in a slow rolling motion inwards and use a plastic scraper to peal off the cured resin sheet. Throw away the resin sheet and your vat is clean.