Gadgets3D LCD Controller case

thingiverse

The Gadgets3D LCD SD card controller case is compatible with any 3D printer, featuring hooks inserts on its backside that accommodate a 7mm gap for hanging purposes, such as a 6mm plywood or other materials. The design was specifically made for a self-sourced Ultimaker. To print this part, use a 0.8mm wall thickness and an infill of 20%. Adjust the speed and layer height according to your preference; however, a recommended best result is achieved with a 0.1mm layer height. For proper printing, make sure the top front face and bottom back face are laid down on the bed to prevent overhangs. After printing, look for thin 2mm screws with a head of +/- 4mm and minimal length of 10mm. Position the LCD controller on the top part and place the bottom part on it before inserting the screws. That concludes the assembly process.