G36 | Futuristic DMR conversion set

cults3d

Hello there, Couldn't find any SL-8 / SL-9 Stock conversion for my G36 GBBR build, so here is my G36's Project - Futuristic CQB/DMR Conversion set. Should fit on most G36s, but built on WE G39 999c IdZ GBB Hardware needed: 1 Glue/Acetone (glueing parts 1 and 2) 2 Bolt and screw with round head (eg. M4/M5 x17 - for silencer to be locked from top) 3 Outter barrel extension, like this one: (135mm)https://gunfire.com/en/products/barrel-extension-for-replica-equipped-with-a-14mm-thread-1152201061.html Parts Guide: Common parts: G36 Set - 1 - Rail Base G36 Set - 2 - Rail Main G36 Set - 3 - Silencer Base (i'd prefer to melt the nut into the part to lock silencer) Short version: G36 Set - 4a - Rail End Short G36 Set - 5a - Silencer Short Long Version (DMR): G36 Set - 4b - Rail End Long G36 Set - 5b - Silencer Long (you can use Short silencer depending on inner barrel's lenght - long is for ~509mm) Stock's Parts: G39 Set - 6 - Stock Conversion G39 Set - 7 - Cheek riser Bonus: G36 Set - 8 - Ambi charging handle - right shorter ( Remix of ohman74's charging handle allowing G39 style stock to be folded when fully extended) Front / Handguard instructions: ( 135mm [M4] outer barrel extension needed) After printing parts no. 1 and 2 glue them together (when printing with ABS/ASA - acetone will do just fine) - protruding flat parts will provide more glueing surface Screw on the 14ccw silencer base on the extension and slide the silencer on (make sure which side is Up / Top) , then mark a place where bolt will be melt into, take silencer out, melt the bolt into (not all the way in, just to bolt be top-to-top with silencer base) Push-in selected rail end (Short/Long variant) - this should be push-fit. Push-in selected silencer and lock it with screw from top SL-8 alike for G39 Style stock Instruction: Take off the back part of the stock by rising stock setting lever (or however You call it) 2 .put it between stock's front and back part, Put stock's back part back and lock it in place by setting lever. / if You are struggling with the lever just pull it out by removing pin, place the part in the stock and replace the lever with pin. Put the cheek riser on and put the screws from the sides into the holes in cheek riser and stock conversion Comments: Make sure you printer will fit all the parts (biggest part is part no. 6 Stock conversion) slaps G36's stock This badboy can fit up to 509mm long inner barrel Handguard part will surely fit on WE G39 (999c IDZ GBBR), not sure about other G36's models Update 08.02.2022: Combining all previous and recent projects into one named as conversion set Update 12.12.2021: Uploaded new futuristic version Uploaded modified-longer version of Chloviss's silencer (so i can hide all my internal barrel in combo of external barrel extension)