G Watch R Charging Dock - Version 2

thingiverse

This stand covers the original G Watch R charging cradle LG SDT-330. Made with Tinkercad, it's an upgraded version of my earlier design found here: http://www.thingiverse.com/thing:619842 \nFeatures: \nThe bracelet does not interfere during charging. \nThe 28 degree incline allows easy viewing and interaction with the watch while charging. \nUSB connection is concealed. The wire exit is shifted to the bottom rear of the stand. \nMultiple designs available. My preference is for the short, rounded version. \nThe cradle is completely covered by the holder, eliminating any jutting parts. \nPrinting and mounting are seamless. \nGlue-free: The cradle and USB cable can be easily detached. \nThere's a long and short variant available. The shorter one works well with the stock USB cable.\n\n \n \n Instructions\nThis stand consists of two parts to simplify printing, with support material enabled for easier results. PLA prints exceptionally well at an infill density of 25%. ABS prints might be tighter due to a more compact design; therefore, I suggest grinding down the entrance to ensure the cradle fits without resistance. The hole in the center enables hassle-free removal of the charging cradle. Following feedback about pillar breakage under stress, I have upgraded the design (..solid) with 3mm walls for enhanced strength. \nTo assemble the charging dock: \nPrint your preferred holder and the stand separately. \nCombine the two parts to confirm a snug fit. \nThen disassemble them again. \nFeed the USB wire through the stand from one end. \nPlace the charging cradle within the holder, making sure it clicks securely into place. \nNext, connect the micro-USB cable to the cradle. \nLastly, combine the two components of the dock and press down firmly until secure. \nFinish by gently pushing the USB wire further back in the trench on the stand's rear.\nNOTE: The holder and cradle should mesh perfectly without adhesives.