FX797 and F3 EVO mount for Eachine E010 Micro Quad (New LightWeight!)

thingiverse

Combined FX797 FPV Camera and Tiny F3 EVO Mount for Eachine E010 Micro Quad / Tiny Whoop If you like my model, please consider using my affiliate links below to purchase recommended parts, or simply click here. Thank you! Features: FX797 fits securely in top, with attachments for a small rubber band to hold it down. Tiny F3 EVO board slots in snugly underneath, held securely by a clip over the front. Easy access underneath the F3 EVO for Micro-JST motor plugs and soldering your wires. Receiver taped underneath. May consider more secure mounting if needed, but seems okay for now. Versions "LightScrewlessV4_E010_F3_FPV_Mount.stl" Lightweight version with tabs for rubber bands. Experimental version yet to be tested. "LightV3_E010_F3_FPV_Mount.stl" - 1 gram lightweight version. "Version_3_E010_F3_FPV_Mount.stl" - 2 gram extra heavy-duty version. Installation Pull down the front of the frame and slide in the Tiny F3 EVO flight controller, push it right in, then release the lip and ensure the clips come over the top of the board and hold it securely in place. You may wish to add some thin double-sided tape for extra security. Printing Note: I recommend printing with support and 100% fan. I used line supports with a density of 30 (zigzag was too difficult to detach). You'll also need a good set of small needle-nose pliers to remove all the support, assuming you have a very basic printer like mine (Prusa i3) Part Details: Requires an Eachine E010 Micro Quad Designed for installing an upgraded full-acro Tiny F3 flight controller board FPV camera/transmitter unit such as a FX797 which is tried and tested, or a cheaper Eachine TX-02. All your own transmitter, headset/FPV gear. Alternatively, if you are a total newbie to all this, I'd highly recommend starting with just the Eachine E010 and the FPV camera/transmitter mentioned, using all the included gear, and using a mount for the camera, such as this. Once you're flying well, consider this upgrade. More information on the Eachine E010 and similar mods can be found in this thread at RCGroups. Print Settings: Printer: Wanhao Duplicator i3 Rafts: No Supports: Yes Resolution: 0.1 Notes: My printer (Prusa i3) required supports everywhere. I used lines and 30% density (only that high to ensure the rubber band hooks were properly supported). Fan at 100%. Infill doesn't matter much. How I Designed This Autodesk Fusion 360 Very easy to use piece of software... recommended.