FWW Health and Ammo Dials

thingiverse

All credits for the dial and rivet go to the respective artists. The only stl work I did was scaling to make them fit together. Tip them instead of me. Links below: https://www.thingiverse.com/thing:3710783 https://www.thingiverse.com/thing:2519990 For use with Fallout: Wasteland Warfare by Modiphius. I recommend you print the decals on vinyl sticker paper. Assembly: Cut the outer edge of the decals with a scissors but leave the center intact; vinyl is sensitive to creasing. Apply the decal and then use the tip of a knife to pierce the white circle and cut out the hole (see pictures). Any damage should be covered once assembled, but be careful with the "Ammo Loads" or "Rads" decals as the rivet does not cover as much damage. To cut the divet of the first and second dial, I recommend using a scissors to cut the white space into strips, then use a knife to cut away the strips (see pictures). Use short rivets for the ammo dial or tall rivets for the health/rads dial. You can clean up any overhanging decal by running a knife around the edges of the dial. I recommend dragging away from the face to avoid peeling or tearing the decal. WIP Notes: The tiny logo decal is incredibly delicate. Getting that to look acceptable may be impossible. It may be best to print an oversized decal and trim the edges with a knife. The rivets fit well when printed with my .4mm nozzle, but are now loose with the .2mm nozzle. Some fine tuning or scaling may be required to get a snug fit that can still spin.