Futaba 14SG Aerial Mount

thingiverse

I designed and printed this after I broke one of the flimsy legs off the aerial mount on my Futaba 14SG. It works fantastically well! Great care must be taken when removing the aerial cable from the old mount, as it won't slide through so will need to be carefully removed by sawing lengthwise down the old mount then extracting the cable. The new printed aerial mount allows for the cable and connector to be very gently slid down it, making life a bit easier in the event this one gets broken. Two very small self-tappers from a Trex 150 are used to secure the aerial body to the new mount. Alternatively, a small length of 1.5mm carbon rod could also be used spanning left to right and sitting above the aerial cable; however, the mount would need to be carefully drilled first.