Fusebox 3 point bed leveling adapter(now with LOGO!)

thingiverse

I created an adapter so that I could use three-point bed leveling on my Fusebox. The screws mount onto the bed frame right at the end of the extrusions and line up perfectly with the third hole on my heated bed. Note: This may not fit your setup exactly, but here's a link to TinkerCAD if you need to make any adjustments: https://tinkercad.com/things/5SHOg6t36YY. All you have to do is ensure that the length works for you and that the center hole lines up with your bed. I recommend printing this piece in ABS, PETG, or HTPLA because it will be exposed to heat from the heated bed. 06/09/2016 - I updated the STL file so that the middle section of the adapter is raised, reducing the need for a longer screw. The orientation was also adjusted to minimize support requirements. 06/16/2016 - I updated the STL file again because the raised middle section was bending under spring pressure. I thickened this area and added beefed-up support for the screw holes, as well as a FuseBox logo. Print Settings: Supports: No Resolution: 0.3 Infill: 30% Notes: I used standard Fusebox print settings with three perimeters, but be aware that infill will only apply to the middle section where spring pressure is applied. Make sure it's enough to prevent bending.