Fury Edge Vape Loading Funnel

thingiverse

Tired of the hassle when loading with your fingers? This custom funnel I designed specifically for my Fury edge by healthy rips snaps into place snugly so that when you're ready to pack the bowl, you won't be losing any loads all over the place. You have to get your 3D printer dialed in with an extrusion multiplier. Measuring from top to bottom (not including the small tapered end) it should measure 1.235 inches with calipers for a nice clicky feel to it. You might have to tape an exacto blade to the top edge a little, so the clicking isn't so tight. Enjoy. Print Settings: Layer Height: 0.1mm Wall Line Count: 2 Top Layers: 6 Bottom Layers: 4 Infill: 20% Print Speed: 45 mm/s Outer Wall: 25 mm/s Used a heated bed at 60 degrees Celsius. Used Brim to hold the part better on the table with 7 brim line count. No supports, might need to rotate it 90 degrees as shown in the Cura picture for orientation. Prints very well.